Table of Contents
Advertisement
SETTINGS MENUS OF THE ENCODER
NETWORK page
Note: It is necessary to restart the encoder to save the
changed settings. Otherwise, the changed settings
will not be saved. Restarting the encoder can be
done on the MAINTENANCE page. Click the
[MAINTENANCE] button in the left column to go to
the MAINTENANCE page and click the [RESTART]
button on the MAINTENANCE page. It will take
around 2 minutes and 45 seconds for the encoder to
become operable after the restart.
56
■ Item Descriptions
Perform the following settings after referring to a network
administrator about the setting items. Perform the
settings only when the SW4 switch on the front panel of
the encoder is set to OFF.
IP ADDRESS
Enter the IP address of the encoder.
When the SW4 switch on the front panel of the
encoder is set to ON, an IP address assigned by
DHCP will be displayed.
The default setting is "192.168.0.10".
SUBNET MASK
Enter the subnet mask of the encoder to connect to
the network.
When the SW4 switch on the front panel of the
encoder is set to ON, a subnet mask assigned by
DHCP will be displayed.
The default setting is "255.255.255.0".
DEFAULT GATEWAY
Enter the default gateway to connect to the network.
When the SW4 switch on the front panel of the
encoder is set to ON, a default gateway assigned by
DHCP will be displayed.
The default setting is "192.168.0.1".
DNS SERVER
Enter the IP address of the DNS server to connect to
the network.
The default setting is "0.0.0.0".
MAC ADDRESS
The MAC address of the encoder will be displayed.
It is impossible to change this value.
SPEED/DUPLEX
Select a transmission speed between the encoder
and a network device such as a switching hub or a
router from the following.
AUTO: Transmission speed will be automatically set.
100BASE-TX FULL DUPLEX: Sending and
receiving data will be performed simultaneously.
100BASE-TX HALF DUPLEX: Sending and
receiving data will be performed alternately.
The default setting is "AUTO".
Advertisement
Table of Contents
