HOW TO USE THE CGI COMMANDS
CONTROLLING THE BIT RATE OF STREAMING VIDEO
AND AUDIO DATA
It is possible to change the bit rate of the encoder. Since the settings of the encoder are not overwritten, the changed
rate will return by turning on/off the encoder.
■ Format
http://(IP address of the encoder)/control4?rate=(parameter value)&ch=(parameter value)
■ Response
HTTP /1.1 200 OK
Cache-Control: no-cache
Content-Type: text/plain
Content-Length: XX
CR
LF
OK or NG
■ Important Notice
• "rate=(parameter value)&ch=(parameter value)" (Required)
■ Item List
Item
Change the bit rate
VIDEO IN connector number
■ Examples
1. To change the bit rate of streaming from the VIDEO OUT 3 connector to 4.6 Mbps
http://192.168.0.10/control4?rate=04&ch=03
2. To return the bit rate of streaming from the VIDEO OUT 3 connector to the set value
http://192.168.0.10/control4?rate=00&ch=04
100
CR
LF
CR
LF
CR
LF
CR
(Store the octet number of the Message-Body decimally)
LF
Parameter name
rate
ch
Parameter value
Description
01=1.5M
Designate the bit rate to be changed.
02=3.0M
03=3.8M
04=4.6M
05=6.1M (150ms)
06=9.2M (150ms)
07=6.1M (100ms)
08=9.2M (100ms)
00=To the set value
reset
01 - 04
Select one of the VIDEO IN connector of
which the bit rate to be changed.