Auto Takeoff And Auto Landing; Starting And Stopping The Motors - dji MATRICE 600 User Manual

MATRICE 600 User Manual
When to Recalibrate
1. The compass data is abnormal, and the Aircraft Status Indicator is blinking red and yellow
alternatively.
2. Flying in a new location, or a location that is different from your last flight.
3. The mechanical structure of the Matrice 600 is changed, i.e. the mounting position of the GPS
module is changed.
4. Severe drifting occurs in flight, i.e. the Matrice 600 has difficulty flying in a straight line.

Auto Takeoff and Auto Landing

Auto Takeoff
Use Auto Takeoff to take off your aircraft automatically if the Aircraft Status Indicator is blinking green.
Follow the steps below to use Auto Takeoff:
1. Launch the DJI GO app and enter the Camera View.
2. Ensure that the aircraft is in P-mode.
3. Go through the pre-flight checklist.
4. Tap and slide Confirm to take off.
5. The aircraft will take off and hover 1.2 meters above the ground, and then raise the landing gear
automatically.
Auto Landing
Use Auto Landing to land your aircraft automatically if the Aircraft Status Indicator is blinking green.
Follow the steps below to use Auto Landing:
1. Ensure that the aircraft is in P-mode.
2. Check that the landing area is clear before tapping
3. The aircraft will lower the landing gear and begin to land automatically.
The landing gear will automatically raise when the aircraft reaches an altitude of 1.2 m for the
first time, and will automatically lower when the aircraft begins to land automatically. Users
can turn this feature ON/OFF in the DJI GO app.

Starting and Stopping the Motors

Starting the Motors
A Combination Stick Command (CSC) is used to start/stop the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
48
©
2016 DJI All Rights Reserved.
to land the aircraft.
OR