Pre-Flight Checklist; Auto Takeoff/Landing - dji MINI 2 User Manual

Pre-Flight Checklist

1. Make sure the remote controller, mobile device, and Intelligent Flight Battery are fully charged.
2. Make sure the Intelligent Flight Battery and the propellers are mounted securely and the propellers
are spread.
3. Make sure the aircraft arms are unfolded.
4. Make sure the gimbal and camera are functioning normally.
5. Make sure that there is nothing obstructing the motors and that they are functioning normally.
6. Make sure that DJI Fly is successfully connected to the aircraft.
7. Make sure that the camera lens and Downward Vision System sensors are clean.
8. Use only genuine DJI parts or parts certified by DJI. Unauthorized parts or parts from non-DJI
certified manufacturers may cause system malfunctions and compromise safety.

Auto Takeoff/Landing

Auto Takeoff
Use auto takeoff when the aircraft status indicator blinks green.
1. Launch DJI Fly and enter the camera view.
2. Complete all steps in the pre-flight checklist.
3. Tap . If conditions are safe for takeoff, press and hold the button to confirm.
4. The aircraft will take off and hover approx. 3.9 ft (1.2 m) above the ground.
The aircraft status indicator blinks green twice repeatedly to indicate that the aircraft is reliant on the
Downward Vision System to fly and can only fly stable at altitudes below 30 m. It is recommended to
wait until the aircraft status indicator is slowly blinking green before using auto takeoff.
DO NOT take off from a moving surface such as a moving boat or vehicle.
Auto Landing
Use auto landing when the aircraft status indicator blinks green.
1. Tap . If conditions are safe to land, press and hold the button to confirm.
2. Auto landing can be cancelled by tapping
3. If the Downward Vision System is working normally, Landing Protection will be enabled.
4. Motors stop after landing.
Choose the proper place for landing.
.
DJI Mini 2 User Manual
©
2021 DJI All Rights Reserved. 41