Mounting The Landing Gear - dji MATRICE 600 User Manual

Mounting the Landing Gear

The antennas are attached to the landing gear legs upon delivery. DO NOT move the
antennas. Pull out the antenna cables from the landing gear legs before mounting.
1. Insert one landing gear leg into each landing skid tube and ensure that the antenna is pointing in
the same direction as the screw hole on the landing skid tube. Secure the landing gear leg in place
by inserting and tightening the M3×8 (cylinder) screw. Be sure to insert the screws from right to left
as shown below to avoid damaging the screw holes.
2. Insert the landing gear leg into the connector on the retractable module. DO NOT damage the
antenna cable. Rotate the landing gear leg until its slots are aligned with the fins in the connector.
3. Pull the antenna cable through the landing gear stopper and insert the stopper into the connector
on the retractable module.
4. Insert two M3×8 (cylinder) screws into the screw holes on the connector and tighten. Be sure to
insert the screws from left to right as shown below to avoid damaging the screw holes.
5. Pull the antenna cable through the retractable module and then connect to the antenna extension
cable at the bottom of the center frame. Then move the antenna protector on the antenna extension
cable to cover the point of connection with the antenna cable.
Antenna
Fins in the Connector
MATRICE 600 User Manual
Antenna Cable
Antenna Cable
Landing Gear
Stopper
Antenna Protector
Antenna Extension Cable
Antenna Cable
©
2016 DJI All Rights Reserved.
11