Additional Keys - Mitsubishi Endeavor Owner's Manual

NOTE
Electronic immobilizer is not compatible with remote
starting systems. Use of these systems may result in vehi-
cle starting problems and a loss of security protection.
A system failure is suspected when the ignition key is
turned to the "START" position, and the engine does not
start. In such a case, contact an authorized Mitsubishi
Motors dealer.
CAUTION
!
Do not make any alterations or additions to the
immobilizer system. Alterations or additions could
cause failure of the immobilizer.
Replacement keys
Only keys that have been programmed to the vehicle electron-
ics can be used to start the vehicle.
If you lose the key, you can order a key from your authorized
Mitsubishi Motors dealer by referring to the key number.
To prevent vehicle theft, the ID code for the vehicle keys must
be changed.
Take your vehicle and all remaining keys to your authorized
Mitsubishi Motors dealer to have your ID code changed.

Additional keys

To add a key, you need to register the ID code to the vehicle.
Registering the ID code can be done by your authorized Mit-
subishi Motors dealer. Or it can be done by yourself (except for
vehicles sold in Canada).
For you to register the ID code yourself, follow the "Customer
key programming" procedure below.
If you choose to have your authorized Mitsubishi Motors
dealer register the ID code, take your vehicle and any remain-
ing keys to your authorized Mitsubishi Motors dealer.
NOTE
You are provided with 2 keys, but you may add up to 6
more keys.
Customer key programming (Except for vehicles
sold in Canada)
You can program new keys to the system if you have 2 valid
(already registered) keys and blank (not registered) immobi-
lizer key (specially cut for your vehicle at your Mitsubishi
Motors dealer) by doing the following:
1. Insert the first valid key into the ignition and turn the igni-
tion to the "ON" position for 5 seconds.
2. Turn the ignition to the "LOCK" position and remove the
first key.
3. Within 30 seconds of turning the first key to the "LOCK"
position, insert the second valid key into the ignition and
turn it to the "ON" position. About 10 seconds later, the
immobilizer indicator will start blinking.
Features and controls
3
3-5