Multi Center Display (If So Equipped) - Mitsubishi Endeavor Owner's Manual

Features and controls
NOTE
The light remains on for a certain period and then goes out
automatically after about 30 minutes.
Refer to "Interior light auto-cutout function (dome light
and other lights)" on page 3-203.
In a vehicle with a multi center display, the multi center
display can be used to stop the warning lamp from flash-
ing and to stop the tone from functioning. For details,
refer to "Setting and customization" on page 3-108.
In a vehicle with a multi center display, if any of the doors
(including the liftgate) is not completely closed while the
ignition key is in the "ON" or "ACC" position, a picture
showing which of the doors (including the liftgate) is ajar
3
appears on the multi center display screen. For details,
refer to "Door open warning" on page 3-107.
3-86
Multi center display
When the ignition key is in the "ACC" or "ON" position, the
display turns on automatically.
WARNING
!
When operating the system for a prolonged period,
make sure the vehicle is parked in a well ventilated
area to avoid the accumulation of toxic fumes inside
and outside of the passenger compartment.
CAUTION
!
The driver should not operate the display while the
vehicle is in motion.
When operating the system, stop the vehicle in a safe
area.
NOTE
Putting a cellular phone in the monitor's small storage
compartment may weaken the phone's reception. This is
typical and does not mean that something is wrong with
the system.
Use of wireless devices such as transceivers near the mon-
itor may make the screen go dark temporarily. This is typ-
ical and does not mean that something is wrong with the
system.
(if so equipped)
N00522100064