Mitsubishi Endeavor Owner's Manual page 373

Comfort controls
NOTE
Once you have stored channels in memory, you can
instantly call up a desired channel by just pushing the cor-
responding memory select buttons (7).
SIRIUS ID indication
If you push the SEEK button (3 or 4) to select "CH 0", the SIR-
IUS ID will be indicated.
5
1. If you select "CH 0", the SIRIUS ID (12 digits) will be
indicated.
2. To stop the SIRIUS ID indication, push the SEEK button
(3 or 4) to select a channel other than "CH 0".
NOTE
If you push the "DETAIL" function button (9), the SIR-
IUS ID will be shown larger.
5-54
To skip or lock a desired channel using the MENU
mode
It is possible to make a setting to skip or lock a desired channel
during channel selection.
1. If you push the AUDIO switch (6) for at least about two
N00700800034
seconds while the system is receiving a satellite radio
channel, the system will switch to MENU mode.
2. In the MENU mode, satellite radio channel SKIP setting
and LOCK setting and volume and equalizing control
with driving speed setting (refer to "Volume and equaliz-
ing control with driving speed" on page 5-47) is possible.
Each time you push the AUDIO switch (6), the status will
change to the next one in the following sequence: "SCV
Select" (the volume and equalizing control with driving
speed setting mode) → "SKIP setting" (the SKIP setting
mode) → "LOCK setting" (the LOCK setting mode) →
Menu mode off
NOTE
The MENU mode will automatically shut off when either
the radio or CD is selected or the user does not move any
of the switches for seven seconds.
SKIP settings, LOCK settings, and the lock cancellation
code are stored in memory. If a battery cable is discon-
nected, they will be erased. (The code will return to the
"1111" that was set at the factory.)
N00701100034