Mitsubishi Endeavor Owner's Manual page 206

3. The date when maintenance was performed on the
selected item will automatically be updated, and the driv-
ing distance until the next scheduled maintenance will
flash.
Press the "+" or "-" button to change the distance until the
next scheduled maintenance. After adjusting the distance
until the next scheduled maintenance, press the "SET"
function button.
NOTE
The driving distance until the next scheduled maintenance
was not set at the factory, so a figure that serves only as a
rough guide is initially shown.
For instructions on setting the calendar, refer to "Date set-
ting" on page 3-130.
The distance until the next scheduled maintenance can be
set in units of 100 miles/km.
The unit for the distance can be set to mile or km.
Refer to "Units customization" on page 3-120.
4. Press the "YES" function button to confirm the mainte-
nance date and distance until next scheduled maintenance
that were set in step 3. If you press the "NO" function but-
ton, the monitor will return to the display in step 2 of this
procedure.
NOTE
The distance indication represents the total distance to be
driven until the next maintenance.
If the setting change is not successful, the monitor will
show "EEPROM is broken" and then return to the display
in step 1 of this procedure.
After replacing a component
After replacing a component, reset the maintenance date and
the distance until the next scheduled maintenance using the
display shown in step 1.
Features and controls
3
N00503000022
3-117