BONFIGLIOLI ACTIVE CUBE Applications Manual page 26

•
•
•
•
Attention! In order to avoid time delays during the processing of the repetition fre-
24
24
If a configuration with speed sensor feedback is selected, check if the speed sen-
sor monitoring is switched on. In this way, faulty speed sensor signals can be de-
tected. Speed sensor monitoring is activated by default. By selecting operation
mode "2 – Error" for parameter
speed sensor monitoring.
Acceleration
Set parameters
Acceleration Anticlockwise
or
required values. For synchronous acceleration and deceleration of the drives, set
the values of the Slave slightly higher than the values of the Master. These in-
creased values are to ensure that the Slave drive can follow the Master drive in
dynamic operation cases.
For a synchronous start of the Master drive and the Slave drive, set the
Frequency
418 of the Slave to 0 in order to prevent a premature start of the
Slave drive if the controller release signal is present at S1IND.
Operation Mode
Select an
Gear Factor Numerator
parameters
quency, the Slave frequency inverter should be released before the Mas-
ter frequency inverter.
Application Manual Electronic Gear
Application Manual Electronic Gear
Operation Mode
Clockwise Deceleration
( ) 420 and
Deceleration Anticlockwise
422 and
689 and adjust the required transmission ratio via
Gear Factor Denominator
685 and
760, you can switch on the
Clockwise
( ) 421
423 to the
Minimum
686.
09/08
09/08