BONFIGLIOLI ACTIVE CUBE Applications Manual page 22

Via parameter
nently depending on the signal state at a digital input.
For contact control, a digital input can be selected and assigned to parameter
Controller Release
digital input is assigned to this parameter in configurations 116, 216 and 516.
A PI controller supplies the percentage value which acts on the reference value of the
electronic gear. Via parameters
adjust the proportional and the integrating part of the index controller.
The maximum percentage value of the output signal of the controller can be adjusted
via parameter
No.
591 Amplification
592 Integral Time
593 Limit
Parameters
control at different numbers of reference marks and thus different frequencies of the
index signals for the Master and the Slave. The parameters can be adjusted according
to the number of Master reference marks / number of Slave reference marks ratio.
No.
594 Master Index Divider
595 Slave Index Divider
Attention! When setting parameters
Via parameter
Master.
No.
596 Offset
20
20
Operation Mode
Operation mode
598
0 - Off
1 - On
2 - Controlled by Contact
96. By default, multifunction input MFI1D which is configured as a
Limit
593, thus the dynamism of the controller can be influenced.
Parameter
Description
Master Index Divider
Parameter
Description
vider
595, note that the period of the divided index signals must at least
be 16 ms since this is the response time of the digital inputs.
Offset
596, you can correct the position of the Slave relative to the
Parameter
Description
Application Manual Electronic Gear
Application Manual Electronic Gear
598, the index controller is switched on or off perma-
Function
The index controller is switched off permanently.
The index controller is switched on permanently.
The index control is switched on or off via a digital in-
put.
Amplification
591 and
Min.
0.0
0.0 ms
0.00%
Slave Index Divider
594 and
Min.
1
1
Master Index Divider
Min.
-50.00%
Index
Integral Time
592, you can
Settings
Max. Fact. sett.
100.0 1.0
60.000 ms 1000 ms
200.00% 10.00%
595 enable index
Settings
Max. Fact. sett.
65 535 1
65 535 1
Slave Index Di-
594 and
Settings
Max. Fact. sett.
50.00% 0.00%
09/08
09/08