Scope Sources; Actual Values - BONFIGLIOLI ACTIVE CUBE Applications Manual

Via parameter
index signals from the Master and the Slave. A setting of e.g. 50% means that a
warning is issued if the displacement between the index signals exceeds 50% of the
period.
No.
597 Warning Limit
Note: The parameter
The warning messages due to a phase error or if the index signal period is too short
can be assigned to a digital output.
150 and 151
The following operation modes are available as signal sources for further linking to
digital inputs.
4.7.1
For the VPlus Scope function two dedicated sources are available.
693 – Master Index
694 – Slave Index
These sources will display the inputs at the two corresponding digital inputs "Index
Signal Master" (S2IND) and "Index Signal Slave" (S3IND).
4.8
Via parameter
the repetition frequency input.
Via parameter
value or the actual frequency value of the speed sensor 1 input, dependent on the use
as reference value input or input for speed sensor feedback.
Via parameter
value or the actual frequency value of the speed sensor 2 input, dependent on the use
as reference value input or input for speed sensor feedback. Speed sensor 2 input is
available if an expansion module EM-ENC or EM-IO is connected.
Via parameter
after multiplication by the gear factor and addition of the optionally selectable repeti-
tion frequencies can be displayed. This parameter is available if a communication
module CM-232/485 or CM-CAN is connected.
09/08
09/08
Warning Limit
Parameter
Description
Warning Limit
chronous behavior of the Master drive and the Slave drive is to be issued.
Operation mode
50 - Synchronization Fault
51 - Signal Fault
Operation mode
Index Contr.:
691 -
Warn. Phase Error
Index Contr.:
692 -
Warning Period

Scope sources

Actual Values

Repetition Frequency Input
Freq. Speed Sensor 1
Freq. Speed Sensor 2
Reference Ramp Frequency
Application Manual Electronic Gear
Application Manual Electronic Gear
597, you can monitor the phase displacement of the
Min.
0.00%
597 should be set if an early warning of asyn-
Function
The phase error exceeded the
Index signal period too short
Operation modes inverted
Function
The phase error exceeded the
Index signal period too short.
252, you can display the actual value of
217, you can display the frequency reference
219, you can display the frequency reference
283, the actual value of the frequency
Settings
Max. Fact. sett.
50.00% 0.00%
Warning Limit
597.
Warning Limit
597.
21
21