Loading An Existing Mold Setup File; Deleting Files; Copying Files; Renaming Files - Husky Altanium Delta3 User Manual

User Guide

6.1.6 Loading an Existing Mold Setup File

After a Mold Setup file has been created it is automatically loaded as the current Mold Setup
in the system.
To load a different Mold Setup, do the following:
1.
2.
3.

6.1.7 Deleting Files

When a file or folder is no longer required on the internal disk, it can be deleted.
To delete a file or folder, do the following:
1.
2.
3.

6.1.8 Copying Files

Mold setups, images, documents or notes can be copied from one folder or device to
another. Only files from folders with the same name or type can be copied into that folder.
For example: a mold setup file can be pasted only into a mold setup folder.
To copy and paste a file, do the following:
1.
2.
3.

6.1.9 Renaming Files

To rename a file or folder, do the following:
1.
2.
3.
Loading an Existing Mold Setup File
v 2.3 — September 2015
On the Mold Setup screen, select the Mold Setup folder that contains the Mold Setup
file to be loaded.
Touch the name of the mold setup file to be loaded.
Touch the Load Mold Setup button to load the selected mold setup.
Once a mold setup is loaded, its name will be displayed at all times on the Mold Setup
Info button in the System Footer.
On the Mold Setup screen, touch the file or folder to be deleted.
Touch the Delete button.
A message appears asking to confirm the deletion. To continue, touch the Accept
button. To cancel the deletion, touch the Cancel button.
On the Mold Setup screen, touch the file to be copied.
Touch the Copy button.
Navigate to the destination folder, and then touch the Paste button to create a copy of
the file.
On the Mold Setup screen, touch the file or folder to be renamed.
Touch the Rename button and enter the new name.
Touch the Accept button to save the name of the file.
Mold Setups
55