Ip Mode; Ip Address; Subnet Mask - Chauvet Maverick MK2 Wash User Manual

Operation
IP Mode The IP address of the Maverick MK2 Wash can be set manually, by the network, or to a pre-set
static address specific to each product. To set the IP Mode, follow the instructions below:
1.
2.
3.
4.
5.
6.
7.
IP Address In Manual IP Mode, the IP address must be assigned through the product menu. To set the IP
address in Manual IP Mode, do the following:
1.
2.
3.
4.
5.
6.
7.
Subnet Mask In Manual IP Mode, the Subnet Mask must be assigned through the product menu. To set the
Subnet Mask in Manual IP Mode, do the following:
1.
2.
3.
4.
5.
6.
7.
In DHCP or Static IP Mode, the IP and SubMask menu settings have no effect on the product.
-34-
Navigate to the Setup menu.
Use <UP> or <DOWN> to select Network Settings, or touch the display where it says Network
Settings.
If using the buttons instead of the touchscreen, press <ENTER>.
Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
If using the buttons instead of the touchscreen, press <ENTER>.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
·
Manual (set the IP address with the control panel),
·
DHCP (the network sets the IP address),
or
·
Static (a pre-set address specific to each product),
or touch the display where it says the desired mode.
Press <ENTER>.
Navigate to the Setup menu.
Use <UP> or <DOWN> to select Network Settings, or touch the display where it says Network
Settings.
If using the buttons instead of the touchscreen, press <ENTER>.
Use <UP> or <DOWN> to select IP, or touch the display where it says IP.
If using the buttons instead of the touchscreen, press <ENTER>.
Set the IP address (from 000.000.000.000 to 255.255.255.255) with one of the following
methods:
·
Through the touchscreen:
a. Touch the display where it shows the byte (set of three numbers) to be changed.
b. Use the number pad on the display to enter the desired number.
c. Repeat until the IP address is set as desired.
·
With the buttons:
a. Use <LEFT> or <RIGHT> to select the byte (set of three numbers) to be changed).
b. Use <UP> or <DOWN> to increase or decrease the value.
c. Repeat until the IP address is set as desired.
Press <ENTER>.
Navigate to the Setup menu.
Use <UP> or <DOWN> to select Network Settings, or touch the display where it says Network
Settings.
If using the buttons instead of the touchscreen, press <ENTER>.
Use <UP> or <DOWN> to select SubMask, or touch the display where it says SubMask.
If using the buttons instead of the touchscreen, press <ENTER>.
Set the Subnet Mask (from 000.000.000.000 to 255.255.255.255) with one of the following
methods.
·
Through the touchscreen:
a. Touch the display where it shows the byte (set of three numbers) to be changed.
b. Use the number pad on the display to enter the desired number.
c. Repeat until the Subnet Mask is set as desired.
·
With the buttons:
a. Use <LEFT> or <RIGHT> to select the byte (set of three numbers) to be changed).
b. Use <UP> or <DOWN> to increase or decrease the value.
c. Repeat until the Subnet Mask is set as desired.
Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 1