Configuration; Control Mode; Control Personalities; Starting Address - Chauvet MAVERICK FORCE 1SPOT User Manual

Operation

Configuration

Use control configurations to operate the product with a DMX, Art-Net™, or sACN controller.

Control Mode

The Maverick Force 1 Spot works with wired DMX, WDMX, Art-Net™, and sACN control signals. To select
which protocol to use:
1. Go to the Settings main level.
2. Select the Control Mode option.
3. Select the desired protocol, from DMX, WDMX, ArtNet, or sACN.
• See the WDMX Reset
• See the

Network Setup

Control Personalities

To set the control personality:
1. Go to the Personality main level.
2. Select the desired personality, from Dmx Mode 25 CH or Dmx Mode 32 CH.
• See the

Starting Address

• Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Starting Address
Each product will respond to a unique starting address from the controller. All products with the same
starting address will respond in unison. To set the starting address:
1. Go to the Address main level.
2. Select the starting address (001–488).
• The highest recommended starting address for Dmx Mode 25CH is 488.
• The highest recommended starting address for Dmx Mode 32CH is 481.
Network Setup
The Network Setup settings control the IP address, subnet mask, and universe of the product.

IP Mode

To choose how the IP address is set:
1. Go to the Network Setup main level.
2. Select the IP Mode option.
3. Select the desired IP mode, from Manual (to set a custom IP address), DHCP (the IP address is
assigned by the connected network), or Static (the product uses a default, preset IP address).

Universe

To assign an Art-Net™ or sACN universe to the Maverick Force 1 Spot:
1. Go to the Network Setup main level.
2. Select the Universe option.
3. Set the universe, from 000–255 (for Art-Net™) or from 001–256 (for sACN).

Manual IP Address

To set the IP address when the IP Mode is set to Manual:
1. Go to the Network Setup main level.
2. Select the Ip option.
3. Set the values of the IP address from 000–255.

Subnet Mask

To set the subnet mask:
1. Go to the Network Setup main level.
2. Select the SubMask option.
3. Set the values of the subnet mask from 000–255.
Maverick Force 1 Spot User Manual Rev. 7
section for further setup of WDMX.
section for further setup of Ethernet protocols (Art-Net™ or sACN).
section for the highest starting address for each personality.
19