Table of Contents
Advertisement
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Go to the Dimmer Curve main level.
2.
Select the desired option (SCurve, Linear, Square, or Inverse Square).
Dimmer Profiles
This setting determines how fast the output of the Ovation Rêve E-3 IP changes when the output value is
modified. It provides four different options to simulate the dimming curve of an incandescent lighting product.
To select a specific dimmer profile, do the following:
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, Dimmer 1 being the fastest.
For optimum control of the 16-bit dimming channels in the 12Ch, 14Ch2, and 18Ch
personalities, ensure that the dimming curves in Dimmer Mode are set to Off.
Color Calibration
This setting determines the maximum output values for each color, which affects the appearance of a full
output white.
1.
Go to the Color Calibration main level.
2.
Select Off (deactivates color calibration), User Calibration, or Factory Calibration (the product
will use a default white setting).
3.
For User Calibration mode, select the color value to edit (Red, Green, Blue, Amber, or Mint).
4.
Set the maximum value for the selected color (125–255).
5.
Repeat steps 3 and 4 until the product outputs as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation Rêve E-
3 IP. To do so, follow the instructions below:
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This setting determines how the fan speed on the Ovation Rêve E-3 IP is set.
1.
Go to the Fan Mode main level
2.
Select Auto (fan speed will increase or decrease based on product temperature), Off (fan will
stay off. Product output will decrease based on product temperature), Silent (fan will maintain a
constant silent speed), or On (fan speed will always be at maximum).
NOTICE: When operating in Fan Mode: Off, the output of the fixture will be reduced
and will not reach the same levels as when using other fan modes.
WARNING: When operating in Fan Mode: Off, the fixture will become hotter to the
touch than when using other fan modes. Use proper protective equipment to prevent
burns. Keep a safe distance from flammable objects.
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation Rêve E-3 IP's display
stays on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On (remains on).
Key Lock
This setting enables users to activate or disable the control panel lock, which keeps non-authorized
personnel from changing the product's settings.
1.
Go to the Key Lock main level.
2.
Select On or Off.
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the Information main level.
2.
Select Fixture Hours, LED Hours, Version, or UID.
18
Ovation Rêve E-3 IP User Manual Rev. 5
Operation
Advertisement
Table of Contents
