Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Automatic Mode
Static Mode
Custom Static
Colors
Page 12 of 17
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until P 1~P 6 shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select P 5 or P 6.
4.
Press <ENTER>.
5.
Turn the music on and adjust the microphone sensitivity knob until the unit responds
to the beat of the music.
The product will only respond to low frequencies of music (bass and drums). If
there is no sound, the product will turn off.
To enable the Automatic mode, do the following:
1.
Press <MENU> repeatedly until P 1~P 6 shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select P 1~P 4.
Press <ENTER>.
4.
5.
Press <MENU> repeatedly until S 1~S100-- shows on the display.
6.
Use <UP> or <DOWN> to adjust the duration of each step of the automatic program
from S 1 (slow) to S100 (fast).
7.
Press <ENTER>.
To enable the Static mode, do the following:
1.
Press <MENU> repeatedly until C 1~C 15 shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the preset color (C 1~C 15).
4.
Press <ENTER>.
To enable the Custom Static Colors mode, do the following:
Press <MENU> repeatedly until U-- shows on the display.
1.
Press <ENTER> and one of the following colors shows on the display: RXXX (red),
2.
GXXX (green), bXXX (blue) or AXXX (amber)
3.
Press <ENTER> repeatedly to select the desired color.
Use <UP> or <DOWN> to select the desired color value (0~100).
4.
NOTE: Selecting 0 will turn the color off.
Press <ENTER> to select color value and continue to the next color.
5.
6.
Repeat steps 3 to 5 until you create your desired color.
SlimPAR™ QUAD 12 IRC User Manual (Rev. 1)
Advertisement
Table of Contents
