Address; Run Mode; Dmx Personality; Auto Test - Chauvet Rogue R3 Spot User Manual

Address

This programming level sets the DMX starting address. In this mode, each product will respond to a unique
starting address from the DMX controller. All products with the same starting address will respond in
unison. This option sets the products DMX address.
1. Starting from the Main Level screen, select Address, press <ENTER>.
2. Select the starting address (001–512), press <ENTER>.

Run Mode

This programming level sets the DMX personality and controls the different test modes.
• Starting from the Main Level screen, select Running Mode, press <ENTER>.

DMX Personality

This setting allows you to choose a particular DMX personality.
1. Highlight DMX, press <ENTER>.
2. Select the DMX personality 19CH or 25CHpress <ENTER>..
• See the
each personality.
• Make sure that the starting addresses on the various products do not overlap due
to the new personality setting.

Auto Test

This option runs every attribute individually through 1 cycle.
• Highlight Auto Test, press <ENTER>.
• The Auto Test will end after 1 full cycle. You can stop the test by pressing
<MENU> at any time

Manual Test

This option allows you to run each attribute individually or as a group.
1. Highlight Manual Test, press <ENTER>.
2. Highlight the desired attribute listed on the control panel screen, press <ENTER>.
3. Set the attribute value (000–255), press <ENTER>.
4. Repeat step 2 for the other attributes.
• When exiting the Manual Test level, the values of all tested channels will revert to
zero.

Setup

This programming level controls the product's head movement, display, dimming, and fan adjustments.
• Starting from the Main Level screen, select Setup, press <ENTER>.
Pan Reverse
Reverses the operation of the pan attribute.
1. Highlight Pan Reverse, press <ENTER>.
2. Select OFF or ON, press <ENTER>

Tilt Reverse

Reverses the operation of the tilt attribute.
1. Highlight Tilt Reverse, press <ENTER>.
2. Select OFF or ON, press <ENTER>

Screen Reverse

Reverses the operation of the tilt attribute.
1. Highlight Screen Reverse, press <ENTER>.
2. Select OFF or ON, press <ENTER>
Page 13 of 27
DMX Value section for the highest starting address you can select for
O
PERATION
Rogue R3 Spot User Manual Rev. 1