Operation
Standalone Configuration
Static Color
To run the Strike Array 2 on a static setting:
1. Go to the Static main level.
2. Select from Dimmer or Strobe.
3. Increase or decrease the value from 000–255.
Automatic Program
To run an automatic program:
1. Go to the Auto Show main level.
2. Select from Auto 1–6.
3. Increase or decrease the Spreed from 001–100.
Settings Configuration
Red Shift
With red shift enabled, the amber LEDs will dim on an inverse curve to imitate a lamp. To enable or disable
the red shift function:
1. Go to the Red Shift main level.
2. Select from On or Off.
Master Slave
To set the Strike Array 2 product to master or slave mode:
1. Go to the Master/Slave main level.
2. Select from Master (sends control signal) or Slave (receives control signal).
•
Configure all the slave products before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
Dimmer Mode
To select the dimmer mode:
1. Go to the Dimmer Mode main level.
2. Select from Off (linear dimmer) or Dimmer 1–3 (fast to slow).
Pulse Width Modulation
To set the PWM frequency:
1. Go to the LED Frequency main level.
2. Select from 600Hz, 1200Hz, 2000Hz, 4000Hz, or 25KHz.
Display Back Light
To select how long a period of inactivity before the display automatically turns off:
1. Go to the Back Light main level.
2. Select from 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On.
Key Lock
To lock or unlock the control panel:
1. Go to the Settings main level.
2. Select the Key Lock option.
3. Select On (locks control panel) or Off (control panel stays unlocked).
When the key lock is activated, the product will prompt for the passcode in order to access
the menu. The passcode is <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
Product Information
To view the product information, go to the Information main level.
Temperature
To view the temperature (in °C) of the LED pods, go to the Temperature main level.
Factory Reset
To reset the product to factory default settings:
1. Go to the Factory Reset main level.
2. Select from No (cancel) or Yes (reset).
Strike Array 2 User Manual Rev. 5
15