Configuration
(Standalone)
Sound-Active
Mode
Sound Sensitivity
Automatic Mode
Totem Mode
Intimidator Spot 355 IRC User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to power.
Never connect a product that is operating in any standalone mode (either
Automatic or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Sound-Active mode, do the following.
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Sound.
5.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To set the sound sensitivity, do the following.
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Sensitivity.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select 001–100, low to high.
7.
Press <ENTER>.
To enable the Automatic mode, follow the instructions below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Auto.
5.
Press <ENTER>.
To activate the Totem Mode, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Totem Mode.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to choose OFF, DOWN, or UP.
7.
Press <ENTER>.
Page 15 of 25