Auto Smartport Default Configuration - Cisco Catalyst 4500 Series Configuration Manual

Configuring Auto Smartport Macros
To enable Auto Smartport macros, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# [no] macro auto
global processing [cdp | lldp]
Step 3
Switch(config)# end
Step 4
Switch# show running-config
Step 5
Switch# copy running-config
startup-config
Use the show shell functions and the show shell triggers privileged EXEC command to display the event
triggers, the built-in macros, and the built-in macro default values.
This example shows how enable Auto Smartport on the switch and how to disable the feature on a
specific interface:
Switch(config)# macro auto global processing
Switch(config)# interface interface_id
Switch(config-if)# no macro auto processing

Auto Smartport Default Configuration

By default, Cisco IOS shell is enabled and Auto Smartport is disabled globally.
Table 19-1
default.
Table 19-1 Auto Smartport Built-in Event Trigger Macros
Event Trigger Name
CISCO_PHONE_EVENT
CISCO_SWITCH_EVENT
CISCO_ROUTER_EVENT
CISCO_WIRELESS_AP_EVENT
CISCO_WIRELESS_LIGHTWEIGHT_AP_EVENT
CISCO_DMP_EVENT
CISCO_IPVSC_EVENT
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
19-4
Purpose
Enters global configuration mode.
Enables Auto Smartport on the switch globally.
Note
Use no macro auto global processing to disable Auto Smartport
globally.
Note
Returns to privileged EXEC mode.
Verifies that Auto Smartport is enabled.
(Optional) Saves your entries in the configuration file.
shows the Auto Smartport built-in event triggers that are embedded in the switch software by
Description
System detects that a phone device is connected to an interface.
System detects that a switch is connected to an interface.
System detects that a router is connected to an interface.
System detects that a wireless application is connected to an
interface.
System detects that a wireless lightweight application is connected
to an interface.
System detects that a digital media player is connected to an
interface.
System detects that an IP video surveillance camera is connected
to an interface.
Chapter 19
Starting with Release 15.0(2)SG, the fallback option has been
deprecated.
The macro auto processing command turns Auto Smartport on
or off on the interface level. The default is on.
Configuring Cisco IOS Auto Smartport Macros
OL-25340-01