Cisco Catalyst 4500 Series Configuration Manual page 475

Chapter 15 Configuring VLANs, VTP, and VMPS
Command
Step 3
Switch(config)# end
Step 4
Switch# show vmps
This example shows how to change the reconfirmation interval to 60 minutes and verify the change:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps reconfirm 60
Switch(config)# end
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 10
VMPS domain server: 172.20.130.50 (primary, current)
Reconfirmation status
---------------------
VMPS Action:
Configuring the Retry Interval
You can set the number of times that the VMPS client attempts to contact the VMPS before querying the
next server.
To configure the retry interval, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# vmps retry count
Step 3
Switch(config)# end
Step 4
Switch# show vmps
This example shows how to change the retry count to 5 and to verify the change:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps retry 5
Switch(config)# end
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 5
VMPS domain server: 172.20.130.50 (primary, current)
Reconfirmation status
---------------------
VMPS Action:
OL-25340-01
Purpose
Returns to privileged EXEC mode.
Verifies the dynamic VLAN reconfirmation status.
1
No Host
Purpose
Enters global configuration mode.
Specifies the retry count for the VPQ queries. Default is 3. Range is
from 1 to 10.
Returns to privileged EXEC mode.
Verifies the retry count.
1
No Host
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
VLAN Membership Policy Server
15-27