Displaying Smartport Macros - Cisco Catalyst 4500 Series Configuration Manual

Displaying SmartPort Macros

Displaying SmartPort Macros
To display the SmartPort macros, use one or more of the privileged EXEC commands in
Table 18-2 Commands for Displaying SmartPort Macros
Command
show parser macro
show parser macro name macro-name
show parser macro brief
show parser macro description
]
interface-id
Configuring Static SmartPort Macros
This section describes how to configure and enable static SmartPort macros:
•
•
•
Default Static SmartPort Configuration
No static SmartPort macros are enabled on the switch.
Table 18-3 Default Static SmartPort Macros
1
Macro Name Description
cisco-global Use this global configuration macro to enable rapid PVST+, loop guard, and dynamic port error recovery
for link state failures.
cisco-desktop Use this interface configuration macro for increased network security and reliability when connecting a
desktop device, such as a PC, to a switch port.
cisco-phone Use this interface configuration macro when connecting a desktop device such as a PC with a Cisco IP
Phone to a switch port. This macro is an extension of the cisco-desktop macro and provides the same
security and resiliency features, but with the addition of dedicated voice VLANs to ensure proper
treatment of delay-sensitive voice traffic.
cisco-switch Use this interface configuration macro when connecting an access switch and a distribution switch or
between access switches connected by using small form-factor pluggable (SFP) modules.
cisco-router Use this interface configuration macro when connecting the switch and a WAN router.
1. Cisco-default SmartPort macros vary, depending on the software version running on your switch.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
18-14
[
interface
Default SmartPort Macro Configuration, page 18-4
SmartPort Macro Configuration Guidelines, page 18-6
Applying Static SmartPort Macros, page 18-15
Purpose
Displays all configured macros.
Displays a specific macro.
Displays the configured macro names.
Displays the macro description for all interfaces or for a specified
interface.
Chapter 18 Configuring SmartPort Macros
Table
OL-25340-01
18-2.