Configuring Mac Address-Table Move Update - Cisco Catalyst 4500 Series Configuration Manual

Configuring MAC Address-Table Move Update

Configuring MAC Address-Table Move Update
These sections contain this configuration information:
•
•
•
Default Configuration
By default, the MAC address-table move update feature is disabled.
Configuration Guidelines
Follow these guidelines to configure the MAC address-table move update feature:
•
•
Configuring the MAC Address-Table Move Update Feature
This section describes the following tasks:
•
•
Configuring a Switch to Send MAC Address-Table Move Updates
To configure an access switch to send MAC address-table move updates, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(conf)# interface interface-id
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
21-10
Default Configuration, page 21-5
Configuration Guidelines, page 21-6
Configuring MAC Address-Table Move Update, page 21-10
Enable mac address-table move transmit on the switch with Flex Links configured to send MAC
address-table move updates.
Enable mac address-table move receive on all upstream switches to process MAC address-table
move updates.
Configuring a Switch to Send MAC Address-Table Move Updates, page 21-10
Configuring a Switch to Receive MAC Address-Table Move Updates, page 21-12
Chapter 21 Configuring Flex Links and MAC Address-Table Move Update
Purpose
Enters global configuration mode.
Specifies the interface, and enters interface configuration
mode. The interface might be a physical Layer 2 interface
or a port channel (logical interface). The port channel
range is 1 to 64.
OL-25340-01