Verifying Ospf Nsf - Cisco Catalyst 4500 Series Configuration Manual

Chapter 11 Configuring Cisco NSF with SSO Supervisor Engine Redundancy
Command
Step 2
Switch(config)# router ospf processID
Step 3
Switch(config-router)# nsf

Verifying OSPF NSF

To verify OSPF NSF, you must check that the NSF function is configured on the SSO-enabled
networking device. To verify OSPF NSF, follow these steps:
Verify that 'nsf' appears in the OSPF configuration of the SSO-enabled device by entering the show
Step 1
running-config command:
Switch# show running-config
route ospf 120
log-adjacency-changes
nsf
network 192.168.20.0 0.0.0.255 area 0
network 192.168.30.0 0.0.0.255 area 1
network 192.168.40.0 0.0.0.255 area 2
.
.
.
Enter the show ip ospf command to verify that NSF is enabled on the device:
Step 2
Switch> show ip ospf
Routing Process "ospf 1" with ID 192.168.2.1 and Domain ID 0.0.0.1
Supports only single TOS(TOS0) routes
Supports opaque LSA
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
Number of external LSA 0. Checksum Sum 0x0
Number of opaque AS LSA 0. Checksum Sum 0x0
Number of DCbitless external and opaque AS LSA 0
Number of DoNotAge external and opaque AS LSA 0
Number of areas in this router is 1. 1 normal 0 stub 0 nssa
External flood list length 0
Non-Stop Forwarding enabled, last NSF restart 00:02:06 ago (took 44 secs)
Area BACKBONE(0)
Number of interfaces in this area is 1 (0 loopback)
Area has no authentication
SPF algorithm executed 3 times
Configuring IS-IS NSF
To configure IS-IS NSF, perform this task:
OL-25340-01
Configuring NSF with SSO Supervisor Engine Redundancy
Purpose
Enables an OSPF routing process, which places the
switch in router configuration mode.
Enables NSF operations for OSPF.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
11-13