Supervisor Engine 6-E And Supervisor Engine 6L-E - Cisco Catalyst 4500 Series Configuration Manual

Chapter 7 Configuring Interfaces
•
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# hw-module module m port-group p
select [gigabitethernet | tengigabitethernet]
Step 3
Switch(config)# exit
Step 4
Switch# show int status mod n
Invoking Shared-Backplane Uplink Mode on

Supervisor Engine 6-E and Supervisor Engine 6L-E

This feature enables you to use all four 10-Gigabit Ethernet ports on the supervisor engines as blocking
ports when in redundant mode.
Prior to Cisco IOS Release 12.2(40)SG, Catalyst 4500 Supervisor Engine V-10GE allowed you to enable
either the dual wire-speed 10-Gigabit Ethernet ports or four TwinGig convertor based Gigabit Ethernet
SFP uplink ports when operating in redundant mode.
OL-25340-01
Invoking Shared-Backplane Uplink Mode on Supervisor Engine 6-E and Supervisor Engine 6L-E
To configure the modes of operation for each X2 port group in which you want to deploy Gigabit,
enter the hw-module module m port-group p select gigabitethernet command. This configuration
is preserved across power cycles and reloads.
To deploy Gigabit Ethernet interfaces using the TwinGig Convertor, perform this task:
This example shows how to select Gigabit Ethernet interfaces on a WS-X4606-10GE-E using the
TwinGig Convertor:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# hw-module module 1 port-group 1 select gigabitethernet
Switch(config)# exit
Switch# show int status mod 1
Port Name
Te1/1
Te1/2
Te1/3
Te1/4
Te1/5
Te1/6
Gi1/7
Gi1/8
Gi1/9
Gi1/10
Gi1/11
Gi1/12
Gi1/13
Gi1/14
Gi1/15
Gi1/16
Gi1/17
Gi1/18
Purpose
Establishes global configuration mode.
Selects the mode of operation for each X2 port-group.
Default is 10-Gigabit Ethernet (x2).
Exits configuration mode.
Verifies the setting.
End with CNTL/Z.
Status Vlan
inactive 1
inactive 1
inactive 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
notconnect 1
inactive 1
inactive 1
inactive 1
inactive 1
inactive 1
inactive 1
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Duplex Speed Type
full 10G No X2
full 10G No X2
full 10G No X2
full 10G No X2
full 10G No X2
full 10G No X2
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
full 1000 No Gbic
7-15