Chapter 39 Configuring Vrf-Lite - Cisco Catalyst 4500 Series Configuration Manual

About VRF-lite
For complete syntax and usage information for the switch commands used in this chapter, first look at
Note
the Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products//hw/switches/ps4324/index.html
If the command is not found in the Catalyst 4500 Series Switch Command Reference, it will be found in
the larger Cisco IOS library. Refer to the Cisco IOS Command Reference and related publications at this
location:
http://www.cisco.com/en/US/products/ps6350/index.html
About VRF-lite
VRF-lite is a feature that enables a service provider to support two or more VPNs, where IP addresses
can be overlapped among the VPNs. VRF-lite uses input interfaces to distinguish routes for different
VPNs and forms virtual packet-forwarding tables by associating one or more Layer 3 interfaces with
each VRF. Interfaces in a VRF can be either physical, such as Ethernet ports, or logical, such as VLAN
SVIs, but a Layer 3 interface cannot belong to more than one VRF at any time.
Note VRF-lite interfaces must be Layer 3 interfaces.
VRF-lite includes these devices:
•
•
•
With VRF-lite, multiple customers can share one CE, and only one physical link is used between the CE
and the PE. The shared CE maintains separate VRF tables for each customer and switches or routes
packets for each customer based on its own routing table. VRF-lite extends limited PE functionality to
a CE device, giving it the ability to maintain separate VRF tables to extend the privacy and security of
a VPN to the branch office.
Figure 39-1
Because VRF-lite is a Layer 3 feature, each interface in a VRF must be a Layer 3 interface.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
39-2
Customer edge (CE) devices provide customer access to the service provider network over a data
link to one or more provider edge routers. The CE device advertises the site's local routes to the
provider edge router and learns the remote VPN routes from it. A Catalyst 4500 series switch can
be a CE.
Provider edge (PE) routers exchange routing information with CE devices by using static routing or
a routing protocol such as BGP, RIPv1, or RIPv2.
The PE is only required to maintain VPN routes for those VPNs to which it is directly attached,
eliminating the need for the PE to maintain all of the service provider VPN routes. Each PE router
maintains a VRF for each of its directly connected sites. Multiple interfaces on a PE router can be
associated with a single VRF if all of these sites participate in the same VPN. Each VPN is mapped
to a specified VRF. After learning local VPN routes from CEs, a PE router exchanges VPN routing
information with other PE routers by using internal BGP (iBPG).
Provider routers (or core routers) are any routers in the service provider network that do not attach
to CE devices.
shows a configuration where each Catalyst 4500 series switch acts as multiple virtual CEs.
Chapter 39 Configuring VRF-lite
OL-25340-01