Configuring Rep Interfaces - Cisco Catalyst 4500 Series Configuration Manual

Chapter 22 Configuring Resilient Ethernet Protocol
To configure the REP administrative VLAN, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# rep admin vlan vlan-id
Step 3
Switch(config)# end
Step 4
Switch# show interface [interface-id] rep detail
Step 5
Switch# copy running-config startup config
This example shows how to configure the administrative VLAN as VLAN 100 and verify the
configuration by entering the show interface rep detail command on one of the REP interfaces:
Switch# configure terminal
Switch (config)# rep admin vlan 100
Switch (config)# end
Switch# show interface gigabitethernet1/1 rep detail
GigabitEthernet1/1 REP enabled
Segment-id: 2 (Edge)
PortID: 00010019E7144680
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 0002001121A2D5800E4D
Port Role: Open
Blocked Vlan: <empty>
Admin-vlan: 100
Preempt Delay Timer: disabled
Load-balancing block port: none
Load-balancing block vlan: none
STCN Propagate to: none
LSL PDU rx: 3322, tx: 1722
HFL PDU rx: 32, tx: 5
BPA TLV rx: 16849, tx: 508
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 118, tx: 118
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 4214, tx: 4190

Configuring REP Interfaces

For REP operation, you need to enable it on each segment interface and identify the segment ID. This
step is required and must be done before other REP configuration. You must also configure a primary
and secondary edge port on each segment. All other steps are optional.
OL-25340-01
Purpose
Enters global configuration mode.
Specifies the administrative VLAN. The range is 2 to
4094. The default is VLAN 1. To set the admin VLAN to
1, enter the no rep admin vlan global configuration
command.
Returns to privileged EXEC mode.
Verifies the configuration on one of the REP interfaces.
(Optional) Saves your entries in the switch startup
configuration file.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring REP
22-9