Redundant Supervisor Mode - Cisco Catalyst 4500 Series Configuration Manual

Digital Optical Monitoring Transceiver Support

Redundant Supervisor Mode

In redundant supervisor mode, WS-X45-SUP-7L-E supports 1+1 (in 10-Gigabit mode) and 2+2 (in
1-Gigabit mode)
Table 7-2
Active Supervisor Uplink
Ports
A1
Choose 10-Gigabit operation through the command line interface.
SFP+
SFP+
SFP
SFP
Digital Optical Monitoring Transceiver Support
Command line interface (CLI) commands (show inventory, show idprom interface) are used on
transceivers to obtain serial number, model name, inventory information.
The following commands are specific to the transceivers that support the DOM capability:
•
•
•
Note This feature is only available when a DOM capable transceiver is present and configured for monitoring.
The frequency at which the sensor information is refreshed depends on default values configured in the
transceiver SEEPROM (Serial Electrically Erasable Programmable Read Only Memory).
Note For details on transceiver module compatibility, refer to this URL:
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
7-18
(Table 7-2).
Uplink Options for Redundant Supervisor Mode
A2 A3 A4
— —
— —
— —
SFP — —
Displays current values and thresholds for all sensor on a particular interface transceiver:
show interfaces int-name transceiver [detail] [threshold]
Enables or disables the entSensorThresholdNotification for all sensors in all the transceivers:
snmp-server enable trap transceiver
Enables or disables transceiver monitoring:
transceiver type all
monitoring
Standby Supervisor Uplink
Ports
B1 B2 B3 B4
SFP+ — —
SFP — —
SFP+ — —
SFP SFP — —
Chapter 7 Configuring Interfaces
Speeds Achievable with this
Combination of Pluggables
20 Gbps
11 Gbps
11 Gbps
4 Gbps
OL-25340-01