Cisco-Router - Cisco Catalyst 4500 Series Configuration Manual

Chapter 18 Configuring SmartPort Macros
# speed up convergence
switchport mode trunk
switchport nonegotiate
# Configure qos to trust this interface
auto qos voip trust
# 802.1w defines the link as pt-pt for rapid convergence
spanning-tree link-type point-to-point
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------

cisco-router

This example shows how to use the system-defined macro cisco-router to assign a value of 451 to the
native VLAN on the Fast Ethernet interface 2/9.
Note This macro requires the $NVID keyword, which is the native VLANs of the port.
Switch(config)# interface fastethernet2/9
Switch(config-if)# macro apply cisco-router
Switch(config-if)# macro description cisco-router $NVID 45I
Switch(config-if)# end
Switch# show parser macro name cisco-router
Macro name : cisco-router
Macro type : customizable
# Access Uplink to Distribution
switchport trunk encapsulation dot1q
# Define unique Native VLAN on trunk ports
# Recommended value for native vlan (NVID) should not be 1
switchport trunk native vlan $NVID [native_vlan_id]
# Update the allowed VLAN range (VRANGE) such that it
# includes data, voice and native VLANs
# switchport trunk allowed vlan $VRANGE [vlan_range]
# Hardcode trunk and disable negotiation to
# speed up convergence
# Hardcode speed and duplex to router
switchport mode trunk
switchport nonegotiate
speed 100
duplex full
# Configure qos to trust this interface
auto qos voip trust
qos trust dscp
# Ensure fast access to the network when enabling the interface.
# Ensure that switch devices cannot become active on the interface.
spanning-tree portfast
spanning-tree bpduguard enable
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------
OL-25340-01
Macro Description
cisco-switch
Macro Description
cisco-router
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring SmartPort Macros
18-13