Configuring Auto Smartports; Default Auto Smartports Configuration - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 14 Configuring Auto Smartports Macros
Figure 14-1
Switch with Auto
Smartports enabled

Configuring Auto Smartports

•
•
•
•
•
•
•
•
•

Default Auto Smartports Configuration

•
•
•
•
Table 14-1 Auto Smartports Built-In Macros
Macro Name
CISCO_PHONE_AUTO_
SMARTPORT
CISCO_SWITCH_AUTO_
SMARTPORT
OL-21521-01
Cisco Medianet Deployment Example
Device Identified through CDP, 802.1x,
MAB, LLDP, MAC address, or OUI
Auto Smartports macro
configuration applied to the port
Default Auto Smartports Configuration, page 14-3
Auto Smartports Configuration Guidelines, page 14-4
Enabling Auto Smartports, page 14-5
Configuring Auto Smartports Default Parameter Values, page 14-6
Configuring Auto Smartports MAC-Address Groups, page 14-7
Configuring Auto Smartports Macro Persistent, page 14-8
Configuring Auto Smartports Built-In Macro Options, page 14-9
Creating User-Defined Event Triggers, page 14-11
Configuring Auto Smartports User-Defined Macros, page 14-15
Auto Smartports is disabled globally and enabled per interface.
CDP fallback is disabled globally and enabled per interface.
Cisco IOS shell is enabled.
Auto Smartports macros are used by default when ASP is enabled for the devices shown in
Table 14-1.
Description
This macro applies the IP phone macro for Cisco IP phones. It enables QoS, port-security,
storm-control, DHCP snooping, and spanning-tree protection. It also configures the access and
voice VLANs for that interface.
This macro applies the switch macro for Cisco switches. It enables QoS and trunking with
802.1Q encapsulation. It also configures the native VLAN on the interface.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring Auto Smartports
14-3