Cisco Catalyst 4500 Series Configuration Manual page 399

Chapter 12 Environmental Monitoring and Power Management
2
3
5
6
M MAC addresses
--+--------------------------------+---+------------+----------------+---------
1 005c.9d1a.f9d0 to 005c.9d1a.f9df 0.5 12.1(11br)EW 12.1(20020313:00 Ok
2 0010.7bab.9920 to 0010.7bab.9925 0.2
3 0050.7356.2b36 to 0050.7356.2b47 1.0
5 0001.64fe.a930 to 0001.64fe.a95f 0.0
6 0050.0f10.28b0 to 0050.0f10.28df 1.0
Switch#
Limitation 2
Certain configurations on the Catalyst 4507R and Catalyst 4510R chassis exceeds the maximum amount
of data power available. These configurations include the combination of the follow PIDs:
•
•
•
•
To maximize the 10/100/1000 port density of 7- and 10- slot chassis, install WS-X4548-GB-RJ45 line
cards instead of WS-X4448-GB-RJ45 line cards. If WS-X4448-GB-RJ45 line cards are required, two
options are available:
•
•
To maximize the 100-BASE-FX port density of 7- and 10- slot chassis, install WS-4248-FE-SFP line
cards with FX optics instead of WS-X4148-FX-MT line cards. If WS-X4148-FX-MT line cards are
required, two options are available:
•
•
Configuring Redundant Mode on a Catalyst 4500 Series Switch
By default, the power supplies in a Catalyst 4500 series switch are set to operate in redundant mode. To
effectively use redundant mode, follow these guidelines:
•
•
OL-25340-01
6 1000BaseX (GBIC)
18 1000BaseX (GBIC)
0 Not enough power for module
48 10/100BaseTX (RJ45)
7-slot configuration
Chassis: WS-C4507R-E, WS-C4510R-E
Dual supervisor engines: WS-X45-Sup6-E and WS-X45-Sup6L-E
One or more: WS-X4448-GB-RJ45 or WS-X4148-FX-MT
Option 1
Only four line card slots can be used on the Catalyst 4507R and six line card slots on the Catalyst
4510R chassis.
Option 2
When all slots are required, only one WS-X4448-GB-RJ45 line card can be used.
Option 1
Only four line card slots can be used on the Cat4507R and six line card slots on the Catalyst 4510R
chassis.
Option 2
When all slots are required only one WS-X4448-GB-RJ45 line card can be used.
Use two power supplies of the same type.
If you have the power management mode set to redundant mode and only one power supply
installed, your switch accepts the configuration but operates without redundancy.
WS-X4306
WS-X4418
WS-X4148-FX-MT
WS-X4148
Hw Fw
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Power Management
00000110
JAB025104WK
00000000000
JAB023402RP
Sw Status
Ok
Ok
PwrDeny
Ok
12-11