Displaying The Operational Status For An Interface - Cisco Catalyst 4500 Series Configuration Manual

Displaying the Operational Status for an Interface

Interface
---------- --------------- --------------------
Gi7/1
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# int gi 7/1
Switch(config-if)# power inline consumption 5000
Switch(config-if)# exit
Switch(config)# exit
The following output displays the power consumption after entering the power inline consumption
command on the interface:
Switch# show power inline gi 7/1
Available:627(w)
Interface Admin
--------- ------ ---------- ---------- ---------- ------------------- -----
Gi7/1
Interface
---------- --------------- --------------------
Gi7/1
Displaying the Operational Status for an Interface
Each interface has an operational status which reflects the PoE status for an interface. The operational
status for an interface is defined as one of the following:
•
•
•
•
•
To view the operational status for an interface, use the show power inline command.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
13-6
AdminPowerMax
(Watts)
15.4
Used:265(w)
Oper
auto on
AdminPowerMax
(Watts)
15.4
on—Power is supplied by the port.
off—Power is not supplied by the port. If a powered device is connected to an interface with external
power, the switch does not recognize the powered device. The "Device" column in the show power
inline command displays as n/a.
Power-deny—The supervisor engine does not have enough power to allocate to the port, or the
power that is configured for the port is less than the power required by the port; power is not being
supplied by the port.
err-disable—The port is unable to provide power to the connected device that is configured in static
mode.
faulty—The port failed diagnostics tests.
AdminConsumption
(Watts)
15.4
End with CNTL/Z.
Remaining:362(w)
Power(Watts)
From PS To Device
5.6 5.0
AdminConsumption
(Watts)
5.0
Chapter 13 Configuring Power over Ethernet
Device Class
Ieee PD 3
OL-25340-01