Debug Interface - Cisco ME 3800X Command Reference Manual

debug interface

debug interface
To enable debugging of interface-related activities, use the debug interface command in privileged
EXEC mode. To disable debugging, use the no form of this command.
Syntax Description interface-id
null interface-number
port-channel
port-channel-number
vlan vlan-id
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(52)EY
Usage Guidelines
If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
Related Commands Command
show debugging
show interface
Cisco ME 3800X and ME 3600X Switch Command Reference
B-6
debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
no debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
Displays debug messages for the specified physical port, identified by type
switch number/module number/ port, for example gigabitethernet 0/2.
Displays debug messages for null interfaces. The interface-number is always
0.
Displays debug messages for the specified EtherChannel port-channel
interface. The port-channel-number range is 1 to 26.
Displays debug messages for the specified VLAN. The vlan-id range is 1 to
4094.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays interface status and configuration information.
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
OL-28238-01