Cisco ME 3800X Command Reference Manual page 520

Hide thumbs Also See for ME 3800X:

Table of Contents

Configuring a UNI count does not prevent you from configuring more endpoints than the configured

count. For example, if you configure a UNI count of five, but you create ten MEPs, any five MEPs in the

domain can go down without the status changing to Partially Active.

This example shows how to a UNI count of two with point-to-multipoint service:

Switch(config)# ethernet evc test1

Switch(config-evc)# uni count 2 multipoint

Related Commands

ethernet evc evc-id

Cisco ME 3800X and ME 3600X Switch Command Reference

Defines an EVC and enters EVC configuration mode.