Ide Interface; Connector - Kontron MOPSlcdLX User Manual

Chapter 16

16. IDE Interface

The MOPSlcdLX features one EIDE interface (Ultra DMA66 mode) that can drive two hard disks. When two
devices share a single adapter, they are connected in a master/slave, daisy-chain configuration. If only one
drive is in the system, you must set it as the master.

16.1 Connector

The IDE interface is available through Connector X15005 (44 pins). This interface is designed in 2mm grid
for optimal connectivity to a 2.5" hard disk.
There are several accessories available for IDE connectivity.
You can use two cables to directly connect a hard disk in a 2.
96 021-0000-00-0) or a 3.5" form factor (KAB-IDE-25, Part Number 96020-0000-00-0).
You can plug a Kontron chipDISK,
interface and mechanically mount it by using a m
DISK adapter (chipD ISK-ADA1,
Number 96004-0000-00-2) for more di support.
The following table shows the pinout.
Header Pin
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
39
41
43
Kontron User's Guide MOPSlcdLX
which is an IDE hard disk tha uses Flash
ini-spa
Part N um ber 960 04-000
sk
Signal Name Function
/RESET Reset
D7 Data 7
D6 Data 6
D5
Data 5
D4 Data 4
D3 Data 3
D2 Data 2
D1 Data 1
D0 Data 0
GND Ground
DRQ DMA Request
/IOW I/O write
/IOR I/O read
IOCHRDY I/O channel ready
/DACK DMA Acknowledge
IRQ Interrupt
SA1
Address 1
SA0 Address 0
/CS1 Chip select 1
NC Not connected
(1) +5V
VCC
GND Ground
30
5" form factor (KAB-IDE-2MM, Part Number
t technology, into the IDE
cer on the chipDISK hole. You also can use a chip-
0-00-0) or compact Flash ad
Pin Signal Name
2 GND
4 D8
6 D9
D10
8
10 D11
12 D12
14 D13
16 D14
18 D15
20 KEY (NC)
22 GND
24 GND
26 GND
28 (2)
CSEL
30 GND
32 NC
NC
34
36 SA2
38 /CS3
40 GND
42 (1)
VCC
44 NC
IDE Interface
apter (CFC-ADA1, Part
Function
Ground
Data 8
Data 9
Data 10
Data 11
Data 12
Data 13
Data 14
Data 15
Key pin
Ground
Ground
Ground
Cable Select
Ground
Not connected
Not connected
Address 2
Chip select 3
Ground
+5V
Not connected