Table of Contents
Advertisement
Chapter 19
19. Crisis Management
Modifying parameters in the Setup of the System-BIOS implies the risk of leaving your system in a unboot-
able state. In case this happens two jumpers exist to reset the settings to the "Fail-Safe Defaults".
In case no battery is connected, then follow these five steps:
‚
Power down the system
ƒ
Remove the tagg
„
Power up the system and enter the BIOS S
…
Before saving your new se
†
The board should be functional now
In case there is a backup batter
‚
power down the system
ƒ
switch th
e second jumper JP7000 as depicted, wait for 3 seconds
„
put the jumper back as it was before
Then continue with the steps from the no battery case.
Kontron User's Guide MOPSlcdLX
ed jumper JP14002 (see the picture)
etup
ttings with "Save & Exit" put the jumper back
y for the real time clock:
35
Crisis Management
Advertisement
Table of Contents
