Table of Contents
Advertisement
Chapter 9
9.
Graphics Interface
The onboard graphics controller supports CRT monitors and a variety of LCD panels with single or dual clock,
color depths of 18/24 bit and resolutions up to UXGA (1600x1200).
9.1
CRT Connector
The CRT monitor interface is available through the X12001 connector
on a standard DSUB-15 CRT monitor connector, an adapter cable is required. A 15-pin DSUB cable is avail-
ab
le from Kontron (KAB-VGA-2, Part Number 96053
Header
To find the location of the CRT connector on t
Layo
ut".
9.2
LCD Panel Connector
The interface for the LCD Panel is available through the X12000 connector (40 pins) on the top side of the
board. This connector represents t
tation of this subsystem complies w
of cables for different display types are available from Kontron. Please refer to the actual cable list on the
Kontron Web site for part numbers an
also is available in a separate document JILI-M???.PDF. The three question marks represent the documents
revision number. You can download this document from the Kontron Web site, or contact your local Kontron
technical support to r
eceive it.
To find the location of the LCD Panel interface connector on the MOPSlcdLX board, please see the Appendix
"Connector Layout".
9.3
Display Power Co
When using a LCD Panel, additional voltages may be required to drive the displays logic and supply the
backlight converter. The display logic may require +5V or +3.3V Backlight converters usually are +5
types. When using a Kontron JILI cable, you do not need to determine such configurations. Display logic
voltage come preconfigured on the JILI cable. On occasion, backlight voltage has to be adjusted on the
cable.
Even though the MOPSlcdLX is a +5V only board, you need to supply the +12V for the backlight converter
additionally when using such a converter type. The onboard +3.3V circuitry and the +3.3V logic voltage of
low-voltage panels are powered by separa
Kontron User's Guide MOPSlcdLX
-0000-00-0).
Pin
Signal Name
1
RED
GREEN
2
3
BLUE
4
GND
5
VSYNC
6
HSYNC
he MOPSlcdLX board, please see the Appendix "Connector
he JILI interface (J
ith the JILI Specification of Kontron Embedded Modules GmbH. A variety
d cable names. A detailed description of the JILI interface standard
nsiderations
te voltage regulators.
17
(6 pins). To have the signals available
Function
Analog video red
Analog video green
Analog video blue
Signal ground
Vertical sync
Horizontal sync
UMPtec Intelligent LVDS Interface). The implemen-
Graphics Interface
DSUB-15
1
2
3
7
14
13
V or +12V
Advertisement
Table of Contents
