Configure The Router Protocol; Enable Routing; Configure Vrrp - 3Com corebuilder 3500 Implementation Manual

Configure the Router
Protocol
RIP-1
Index Mode
1 learn
2 learn
3 learn
4 learn
5 learn

Enable Routing

Configure VRRP

VRRP parameters for
Router 1
Configure a dynamic routing protocol (RIP-2 or OSPF) for both Router 1
and Router 2. In this case, the sample configuration uses RIP-2. Use the
menu in the Administration Console or use the IP RIP Web
ip rip
Management forms to configure RIP on both routers.
RIP-2 Compatibility
Mode Mode
enabled disabled
enabled disabled
enabled disabled
enabled disabled
enabled disabled
You must explicitly turn routing on to enable your router to learn and
advertise IP packets. Use
use the IP Routing Web Management form to enable the routing state on
both routers.
Configure the virtual router parameters on Router 1 and Router 2 so that
each routing interface has a backup in case of failure. Each VRID number
is associated with both a VLAN index number and the VID's IP interface
established earlier in this procedure. In the case of a backup router, notice
that you associate the IP address of the interface you want to back up.
VLAN
Index IP Interface
2 10.1.0.254
3 10.1.4.254
4 10.1.8.254
5 10.1.12.254 Backup 4
6 150.100.0.4 Primary
Route
Aggregate Cost
enabled 1
enabled 1
enabled 1
enabled 1
enabled 1
in the Administration Console or
ip routing
Virtual IP
Router Association
Type VRID Address
Primary 1 10.1.0.254
Primary 2 10.1.4.254
Backup 3 10.1.8.253
10.1.12.253 1
5 150.100.0.4 1
Implementing VRRP
Poison Advertisement
Reverse Addresses
enabled 255.255.255.255
enabled 255.255.255.255
enabled 255.255.255.255
enabled 255.255.255.255
enabled 255.255.255.255
Interval Priority Preempt
1 100 yes
1 100 yes
1 100 yes
100 yes
100 yes
325