Programmed Scan Operation; Memory Scan Operation - Icom IC-7000 Instruction Manual

Hold down [MENU/GRP] for 1 second.
Selection from: M, S or G(Graphic)
Push [MENU/GRP] momentarily.
Selection from: S-1, S-2 or S-3
q Select S-2.
w Push [F-3 V/M] to select VFO mode.
e Select the desired operating mode.
scanning.
r Set [RF/SQL] open or closed.
[RF/SQL] control function is set as "AUTO,"
the squelch is always open in SSB, CW and RTTY
modes. See pages 1, 35, 129 for details.
t Push [F-1 SCN] to start the scan.
y When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the
resume setting and the squelch condition.
u To cancel the scan push [F-1 SCN].
NOTE: If the same frequencies are programmed
into both scan edge memory channels 1A and 1B,
programmed scan does not start.
q Select the desired memory bank, if necessary.
Push RIT] momentarily to select the
M-ch/RIT function, if the twin PBT is selected.
indicator (Green) goes out.
Rotate [RIT] (outer) control to select the desired
memory bank.
w Select S-2.
e Push [F-3 V/M] to select memory mode.
r Close the squelch with [RF/SQL].
t Push [F-1 SCN] to start the scan.
y When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u To cancel the scan push [F-1 SCN].
NOTE: Two or more memory channels must be
programmed for memory scan to start.
Either Either
Y Y or Z Z
or
[RF/SQL]
[RF/SQL]
[RIT] (outer) control
SCAN OPERATION
[MENU/GRP] [F-1] [F-3]
then push [F-1 ]
[MENU/GRP] [F-1] [F-3]
then push [F-1 ]
9
Select
VFO mode
9
Select
memory mode
112