Rise Time; Paddle Polarity; Keyer Type; Mic U/D Keyer (Hm-103) - Icom IC-7000 Instruction Manual

D

3 Rise Time

This item sets the envelop rise time during which the
output power reaches the set transmit power.
Tx
Key action
Rx
Tx output power
0

4 Paddle Polarity

This item sets the paddle polarity.

5 Keyer Type

This item selects the keyer type for [KEY] connector
on the rear panel.

6 MIC U/D Keyer (HM-103)

(Microphone's [UP]/[DN] switches keyer)
This item allows you to set the microphone [UP]/
[DN] switches to be used as a paddle.
D
Connect a CW paddle as at r ight to operate
an electronic keyer from the front panel [MIC]
connector.
connector only.
P a d d l e P o l a r i t y ,"
"Keyer Type" "MIC U/D Keyer (HM-
103)" in the keyer Set mode. (see above)
OT" and "DASH to activate the
squeeze operation.
Set Tx power level
Time
MIC]
OT" side.
RECEIVE AND TRANSMIT
[F-4 DEF] for 1 second to select a
default setting. (default: 4 seconds)
[F-4 DEF] for 1 second to select a
default setting. (default: Normal)
selected.
[F-4 DEF] for 1 second to select a
default setting. (default: ELEC-KEY)
[UP]/[DN] switches can be used for CW.
[UP]/[DN] switches cannot be used for CW.
[F-4 DEF] for 1 second to select a
default setting. (default: OFF)
NOTE: When "ON" is selected, the frequency and
memory channel cannot be changed using the [UP]/
[DN] switches.
CW
paddle
DOT
3.9 kΩ ±5%
2.2 kΩ ±5%
DASH
NOTE: The HM-103 can be operate as a CW
paddle from both of the front panel and rear panel
mic connector. But the HM-103 is not available the
squeeze operation.
MIC connector
E
MIC U/D
4
4
50