Training Mode - Sam4s ER-5200 Operation And Program Manual

Training Mode

A training mode is available so that you can operate the cash register without updating totals
and counters. Note the following conditions:
To Enter Training Mode
There are two ways to enter the train mode. One is by training password and the other is
by training clerk. First, you must program a training password
To Exit Training Mode
ER-5200/40/15
•
The receipt and journal print the message "TRAINING MODE BEGIN" when
training mode is activated.
•
The receipt and journal print the message "TRAINING MODE END" when
training mode is exited.
•
The message "TRAINING MODE" prints on each receipt printed while training
mode is active.
•
The journal does not print during training mode.
1. Turn the control lock to the X position.
2. To begin the program, enter 199, press the SBTL key.
1 9 9
3. Input Training Password # and press X/TIME key.
PASSWORD #
1. Turn the control lock to the X position.
2. To begin the program, enter 199, press the SBTL key.
1 9 9
3. Input Training Password (Zero is the default code) and press X/TIME key.
0 X/TIME
SBTL
X/TIME
SBTL
Operating Instructions • 25