Training Mode - Sam4s ER-900 Series Operation & Programming Manual

Training Mode

A training mode is available so that you can operate the cash register without
updating totals and counters. Note the following conditions:
To Enter Training Mode
There are two ways to enter the training mode. One is by training password and the
other is by signing on as training clerk. First, you must program a training password
To Exit Training Mode
26 
 The receipt and journal print the message "TRAINING MODE BEGIN" when
training mode is activated.
The receipt and journal print the message "TRAINING MODE END" when

training mode is exited.
 The message "TRAINING MODE" prints on each receipt printed while
training mode is active.
Alternatively an individual employee can be programmed as training

1. Turn the control lock to the X position.
2. To begin, enter 199, press the SBTL key.
1 9 9
3. Input the Training Password # (1111 is default) and press the
QTY/TIME key.
PASSWORD #
1. Turn the control lock to the X position.
2. To Exit, enter 199, press the SBTL key.
1 9 9
3. Input the Training Password (Zero is the default code) and press the
QTY/TIME key.
0 X/TIME
SBTL
X/TIME
SBTL