Nagra Seven Operating Instructions Manual page 97

"Directory nearly full"
"Disk nearly full"
"Disk error"
"Disk Jam"
"Error: Used for copy"
"Error: Used for
Working folder"
"File already exists"
"File open error"
"Idle"
"In Use"
"List Full"
"Low battery"
"Power lost
During last session"
"Reading Error"
"Suspended"
"Unlock"
"Writing Error"
"Waiting for trigger"
"Writing for ext. TC"
Chapter V
Will be displayed when the Nagra Seven is set to pre-record / record for the 995
in the current working folder. Delete unnecessary folders / indexes on your
destination media. (Maximum allowed number of entries is 999)
Destination media (containing the current working folder) is almost full. Delete
unnecessary folders/indexes on your destination media. Then execute the RETRY
function.
Change the media. Execute the RETRY function. The incomplete copy items will
continue on this new media.
Media not responding.
Media not responding.
The copy destination has been selected as the working folder
An attempt to delete the working folder has been made
An index with the same number exists on the destination disk. There are two
solutions. Use the skip function to ignore this index, or Abort to stop the copy
process. Use Overwrite or overwrite all in the copy status menu.
An error occurred when opening the chosen file
The copy list is empty, no copies are running, no errors on previous copy.
The destination folder is in use. Attempt to copy to the working folder has been
requested which is not allowed.
The copy list can contain up to 20 items. This list is full and you can't add another
copy at this time.
Attached battery pack is almost exhausted.
Execute the RETRY function to continue the copy process.
Initially use the RETRY function. If the error re-appears your index or your disk may
be damaged.
The Nagra Seven is in record mode and the current copy destination is the same drive
as the working folder (Copy will always go to the other drive). The copy is
suspended to avoid file fragmentation on the disk and to guarantee you a reliable
remaining recording time.
Internal clocks are no longer locked to the selected reference.
Initially use the RETRY function. If the error re-appears your disk
may be damaged.
Unit is waiting for a remote start signal.
Unit is waiting for a valid external time code signal.
96
th
file
March 2014