Ethernet Connector - Nagra Seven Operating Instructions Manual

Ethernet connector

USB port
Start / Stop connection
Chapter II
The RJ45 Ethernet connector is use to connect the NAGRA Seven to the
internet and will allow file transfer using FTP and Voice Over IP (VOIP) and
is planned to permit streaming of live audio in the future. The yellow led in
the connector will light when an active ethernet cable is connected and the
green led will light when communication data is being transmitted.
The Micro USB connector is of the A/B style, and serves not only as a slave
port, allowing the Seven to be connected to a computer and appear as an
external device, but via the appropriate adapter (Part number 20 70119
000) it can be used as a host port and can accept an external device such as
a keyboard, mouse or a USB thumb drive.
This miniature 3.5mm jack is a remote start / stop connection or "fader
start". It is a simple contact closure and activation is achieved by making a
short-circuit between the terminals. The "polarity" can be selected in the
menus, and if the position "Inverted" is selected, then the function will be
activated when the connection is shorted out as opposed to "open". The
function depends on the position of the main function switch. In the record
position, it will switch between record and test modes. If the pre-record
function is active then the start / stop will switch between record and Pre-
record. In playback it will switch between playback and stop.
11 July 2014