Nagra Seven Operating Instructions Manual page 94

Edit method 2: Creating a new edit by assembling audio portions:
In this method, a new edited audio track is being created by taking either entire source tracks and adding the
together (end-to-end) or inserting different portions of audio at a specific point in the edit track.
Start the editor function by pressing the scissors on the main display. Press the SKIP forward / backwards keys
to locate the initial source track where the editing should begin.
The portion of audio between the two points will
immediately be copied from the source track to the
edit track as shown below.
The upper source track is the active track and the
next piece of desired audio can now be located. It
will in turn be added to the edit track thus building
up the newly created track.
The next piece of audio may also come from a
different index if necessary.
Each audio portion added will be inserted into the edit track at the point where the cursor on the edit track is
currently located.
Once all the audio segments have been assembled activate the edit track by clicking on it.
Chapter IV
Use the display or potentiometers to locate the first
"IN" point, where the new Edit track should
commence and press the "IN" button. Scroll forwards
and press the "OUT" button.
93 March 2014