Nagra Seven Operating Instructions Manual page 92

Press the "ALL" button to select the entire audio take to the lower editing track and the following display will
be shown.
Using either the touchscreen, with a stili pointer, or alternatively the two channel potentiometers move the
edit track graphic display to the start of the audio portion to be removed.
Press the "MARK" button (which will light red) to place the mark or CUT point. Move the audio along to the
second desired mark or "CUT" point and press the MARK button again. The two cut points are now apparent,
as shown in the pictures below.
Chapter IV
On the lower graphic, the end of the copied source
file can be seen on the left side of the display. It is
now possible to join the next piece of audio to this if
desired, but in this example, only unwanted parts of
audio are to be removed from the file using the
editor.
Currently the upper display is active (White).
Click on the lower display to select the edit track to
be active.
Current location
First edit point
91 March 2014