Throttle And Choke Cable Inspection; Carburetor Adjustment; Fuel Injection System; Fuel And Oil Filters - Sea-doo 2001 GS Operator's Manual

Throttle and Choke Cable
Inspection
Throttle Cable
Depress and release the throttle lever.
It should operate smoothly and return
to its initial position without any hesi-
tation. Refer to an authorized Sea-Doo
dealer if necessary.
Carburetor-Equipped Models
Do not activate throttle lever unneces-
sarily, when engine is not running. Car-
buretors are equipped with fuel accel-
erator pumps. These pumps deliver
fuel to the engine each time throttle
lever is depressed.
All Models
WARNING
Do not alter or tamper with throt-
tle cable adjustment or routing.
WARNING
If throttle lever does not automat-
ically return, do not operate water-
craft and see your authorized Sea-
Doo dealer.
F01K01Y
1. Should move freely
Carburetor-Equipped Models
Choke Cable
Ensure choke cable operates smoothly
and without any hesitation from fully
opened to fully closed. When the choke
lever is fully pulled, choke should be ful-
ly applied. Refer to an authorized Sea-
Doo dealer if necessary.
84

Carburetor Adjustment

Carburetor adjustment is very impor-
tant to allow good engine operation and
therefore watercraft performance. Car-
buretor adjustment requires technical
knowledge and experience to have the
correct mixture supplied to the engine.
CAUTION: Serious engine damage
can occur with improper carburetor
adjustment.

Fuel Injection System

RFI and DI Models
The fuel injection system inspection
should be performed by an authorized
Sea-Doo dealer.
CAUTION: Never use injector clean-
ing products. They may contain ad-
ditives that could damage injector
components.
All Models

Fuel and Oil Filters

The fuel filter and the oil filter should be
replaced by an authorized Sea-Doo deal-
er. Fuel system pressurization should
be conducted at the same time.
CAUTION: An obstructed oil filter
will cause oil starvation resulting in
serious engine damage.

Steering Alignment

When the handlebar is directed in straight
ahead position, the jet pump nozzle
1
should be in the same direction allowing
the watercraft to run in a straight line.
Refer to an authorized Sea-Doo dealer
if an adjustment is necessary.
www.SeaDooManuals.net
WARNING
Ensure the handlebar and jet pump
nozzle operate freely from side to
side and are not stressing the steer-
ing cable or brackets.