Handling Sd Memory Cards - Panasonic AJ-HPX2000 Operating Instructions Manual

Handling SD memory cards

An SD memory card may be inserted or removed, either before or after the power is turned on.
To insert an SD memory card
Open the lid of the switch cover, and insert an SD memory
card (optional accessory) into the SD memory card slot
with the notch upward. Close the lid.
Note
An SD memory card must be inserted with the right side
facing the slot. If the card is hard to insert, it may be
reversed or upside down. Do not force it into the slot.
Check the card before re-inserting it.
Formatting, Writing and Reading an SD memory card
To format an SD memory card, write settings data or read
data on an SD memory card, navigate the menu to the
<SD CARD READ/ WRITE> screen from the FILE page.
# < SD CARD READ/WRITE >
R.SELECT
READ
W.SELECT
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ********
2: ********
3: ********
4: ********
If an SD memory card that is formatted in a standard other
than the SD standards and SDHC standards, [FORMAT
ERROR] is displayed in the top right section of the window.
In this case, reformat the card as follows. Note that the
indication "FORMAT ERROR" does not disappear if the SD
memory card is replaced with this menu page open. When
the SD memory card is replaced, perform TITLE READ.
84 Adjustments and Settings for Recording : Handling data
:1
:1
5: ********
6: ********
7: ********
8: ********
To remove the SD memory card
Open the lid of the switch cover, and ensure that the BUSY
lamp is not illuminated. Then, further depress the SD
memory card towards the main unit. This releases the SD
memory card from the insertion slot. Take hold of the SD
memory card and remove it. Close the lid.
SD memory cards must not be used or stored in an
environment where they may be
Exposed to high temperatures/humidities;
Exposed to water droplets; or
Electrically charged.
For storage, the SD memory card must be kept inserted
into the unit with the lid closed.
To format an SD memory card
Note
SD memory cards may be formatted via the thumbnail
screen. For more information, see [Formatting SD memory
cards] (page 123).
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
2
Turn the JOG dial button to move the cursor to the
menu option CARD CONFIG.
3
Press the JOG dial button to display the following
message:
CONFIG?
YES
#
NO