Ctl Count Setting And Display - Panasonic AJ-HPX2000 Operating Instructions Manual

CTL Count Setting and Display

By setting the DISPLAY switch to "CTL", CTL count is
displayed on the time count indication of the LCD display
window.
The CTL count is displayed in ±12 hours with non-drop-
frame.
The playback order of clips recorded on a P2 card is not
linear as for VTRs. It is organized according to thumbnail
operations or exchanging P2 cards, and the priority of
recorded clips will be altered. Therefore, different CTL
counts are displayed for recording mode and playback
mode, respectively.
CTL count for recording mode (recording CTL)
Recording CTL count is displayed during recording mode
(REC, REC/PAUSE, STOP and REC REVIEW), and the
count continues from the end point of the previous
recording. Recording CTL count is retained even if the
power is turned off. When the power is next turned on, the
count continues from the previous value.
Notes
If the RESET button is pressed while the recording CTL
count is being displayed, only the recording CTL count is
reset. Note that reset is disabled during the REC
REVIEW operation.
24 frames are counted in the 24PN (Native) mode.
CTL count for the playback mode
(playback CTL)
During playback mode (PLAY, FF, REW, PLAY/PAUSE),
playback CTL count is displayed.
Whenever the playback order of clips is altered (clips are
sorted by shooting dates), previous playback CTL count is
disabled. The first frame of the first clip is used as a
reference value for recalculation, and the new playback
CTL count is displayed.
Example:
First frame
Clip 1
00:00:00:00 00:01:00:00
Clip 1
00:00:00:00 00:01:00:00
68 Adjustments and Settings for Recording : Setting Time Data
Current value
Clip 2 Clip 3
00:02:00:00 00:03:00:00
Delete Clip 2.
Current value
Clip 3
00:02:00:00
The playback order of clips is altered when either of the
following occurs:
Clips are deleted, copied or restored, or the P2 card is
formatted.
The thumbnail display is switched (for more information,
see [Switching the Thumbnail Display] (page 113)).
A P2 card is inserted or removed.
The reference value (value of the first frame of the first clip)
is changed when either of the following occurs:
The power is turned on, the first frame becomes 0.
When the playback CTL count is reset, the current
playback position is set as 0, and the previous reference
value becomes a negative value.
Example:
First frame
Clip 1
00:00:00:00 00:01:00:00
First frame
Clip 1
–00:03:00:00 –00:02:00:00
Notes
If the RESET button is pressed while the playback CTL
count is being displayed, only the playback CTL count is
reset.
For playback in 24PN (Native) mode, 30 frames are
counted in accordance with the pull-down images.
Current value
Clip 3
Clip 2
00:02:00:00 00:03:00:00
Reset
Clip 2
Clip 3
–00:01:00:00 00:00:00:00